諸暨市福迅機械廠

PE管焊接機，63-160四環手動熱熔機/PE熱熔機焊接全過程(操作使用說明) 

熱熔對接機中無論是手動型，還是液壓型，加熱板和銑刀是必須的，不同的是前者依靠人工操控，后者由液壓系統提供動力，實現液壓自動控制，尤其對于口徑較大的管道，在銑、加熱和冷卻時都需要很大的壓力，人力一般很難做到。整個對接過程大致可以分為：放、銑、熱、冷幾個步驟， 

  管材固定
把管材固定在機架上，中間留出5-8厘米的距離。
The carriage Jawws are clamped around the pipe.

  1.銑削
將銑刀放入機架，適當調整切削壓力對管材端面進行切削。待形成連續切割后緩慢減小切削壓力，并撤出銑刀，以保證管材端面光滑平整。
The pipe ends are faced flat & parallel to each other to give a good mating for fusion.

  2.管端加熱
加熱板待恒溫后放入機架對管材端面進行加熱，并根據管徑及環境溫度來調整加熱時間及壓力。
The heater is placed into machine， Both pipe ends are brought together against the heater.

  3.焊接
管端加熱后迅速將加熱板移開，然后立即將管材對接，并根據管徑的不同進行對接壓力調整。
The pipe soaks against the heater and begins to melt. Both ends are brought together and beg in to bond immediately.

  4.完成
當焊口溫度降到與環境一致時，將管材自焊接機上移開。完全的接口強度可達到甚至超過本身的強度。
The pipe is held at pressure until cool leaving a joint stronger than the pipe.

由諸暨市福迅機械廠提供

咨詢熱線:(0)15805859856